To align lathe centers using a dial indicator and a test bar, the plunger of the dial indicator should be set to ________?

Question

31-10-2023
Engineering

College

We appreciate your visit to To align lathe centers using a dial indicator and a test bar the plunger of the dial indicator should be set to. This page offers clear insights and highlights the essential aspects of the topic. Our goal is to provide a helpful and engaging learning experience. Explore the content and find the answers you need!

To align lathe centers using a dial indicator and a test bar, the plunger of the dial indicator should be set to ________?

Answer :

Other Questions

In which number does the 5 represent a value 10 times the

For the function [tex]f(x) = x^5 - 5x^4 + 15[/tex], what are

How many milliliters of liquid does the smaller graduated cylinder contain? (3

Translate the following verbal statement into an algebraic expression. Use [tex]x[/tex] for

I was in full-on panic mode. Here I was on my first

Complete the equation: 5 11/16 lb = _ oz. A. 91 oz

The beneficial effects of moderate alcohol consumption are especially true during which

Which three duty roles are required to perform Accounting Hub setup tasks?

∠WXZ is a right angle. If m∠WXV is eleven more than three

A wave travels at a speed of [tex]$242 \, \text{m/s}$[/tex]. If the

EugeneMarie EugeneMarie · Answer 1 · 2024-12-19T07:15:18-05:00

Final answer:

To align lathe centers using a dial indicator and a test bar, the plunger of the dial indicator should be set parallel to the axis of rotation. The plunger should be properly adjusted and seated against the test bar. The lathe centers can then be adjusted based on the readings of the dial indicator.

Explanation:

To align lathe centers using a dial indicator and a test bar, the plunger of the dial indicator should be set parallel to the axis of rotation. This ensures that the indicator accurately measures any variation in alignment between the centers.

When setting the plunger, it is important to make sure it is properly adjusted and seated against the test bar. This can be done by gently tapping the plunger until it is snugly in place.

Once the plunger is set, the lathe centers can be adjusted by moving either the tailstock or headstock until the dial indicator reads zero or within the acceptable tolerance range.