High School

We appreciate your visit to A typical setting for the high pressure cut out control on a recovery unit used for evacuating the refrigerant from a low pressure chiller is. This page offers clear insights and highlights the essential aspects of the topic. Our goal is to provide a helpful and engaging learning experience. Explore the content and find the answers you need!

A typical setting for the high-pressure cut-out control on a recovery unit used for evacuating the refrigerant from a low-pressure chiller is:

a) 2 psig
b) 5 psig
c) 10 psig
d) 15 psig

Answer :

Final answer:

The high pressure cut-out control on a recovery unit used for evacuating the refrigerant from a low pressure chiller is typically set at 10 psig. This allows efficient operation and protects the system from damaging high pressures.

Explanation:

The setting for the high pressure cut-out control on a recovery unit used for evacuating the refrigerant from a low pressure chiller, such as in HVAC systems, is dependent upon the specific system requirements, but one common setting is 10 psig (option c). This setting allows the system to operate efficiently while avoiding undue pressure that could potentially damage the system. It's important to understand that this setting might differ based on the manufacturer's design parameters and system requirements.

Learn more about Refrigerant Evacuation here:

https://brainly.com/question/32158816

#SPJ11

Thanks for taking the time to read A typical setting for the high pressure cut out control on a recovery unit used for evacuating the refrigerant from a low pressure chiller is. We hope the insights shared have been valuable and enhanced your understanding of the topic. Don�t hesitate to browse our website for more informative and engaging content!

Rewritten by : Barada

Final answer:

The typical setting for the high-pressure cut-out control on a recovery unit used for evacuating the refrigerant from a low-pressure chiller is 15 psig.

Explanation:

The typical setting for the high-pressure cut-out control on a recovery unit used for evacuating the refrigerant from a low-pressure chiller is d) 15 psig. The high-pressure cut-out control is a safety feature that shuts down the recovery unit when the pressure exceeds the set limit. In this case, the set limit is 15 pounds per square inch gauge (psig).

It is important to set the high-pressure cut-out control at a level that ensures the safety of the system and prevents any potential damage or accidents. By setting it at 15 psig, it allows for a margin of safety to accommodate any temporary increases in pressure.

Learn more about High-pressure cut-out control here:

https://brainly.com/question/32473347

#SPJ6